Maintenance - Makita 906 Betriebsanleitung

Operation (Fig. 4)
Turn the tool on without the wheel point making any
contact with the workpiece and wait until the wheel
point attains full speed. Then apply the wheel point to
the workpiece gently. To obtain a good finish, move
the tool in the leftward direction slowly.
CAUTION:
• Apply light pressure on the tool. Excessive pressure
on the tool will only cause a poor finish and over-
loading of the motor.
• The wheel point continues to rotate after the tool is
switched off.
Dressing wheel point (Fig. 5)
When the wheel point becomes ''loaded'' with various
bits and particles, you should dress the wheel point
with the dressing stone.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Important:
Wheel points shall be stored and handled with care.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
5