Residual Risks; Initial Start-Up; Securing The Disc Sanding Device; Mounting / Dismounting The Sanding Table - Parkside PTSG 140 C2 Originalbetriebsanleitung

GB NI CY
• Water must be kept away from the
power tool's electrical parts and people
within the working range.
• Caution! Never remove any
loose splinters, chips or jammed
pieces of wood when the sand-
ing disc is still running. Always
switch off the machine before repairing
any faults or removing jammed pieces
of wood - pull the mains plug.
• If the power tool's mains
connection cable is damaged, it
must be replaced with a specially
prepared mains connection
cable, which is available from
the online shop
(www.grizzlytools.shop).

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear protec-
tion is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding discs.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic fi eld which, under certain
circumstances, may impair the
10
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.

Initial start-up

Avoid unintentional start-
ing. Ensure that the mains plug is
removed before carrying out any
adjustments, maintenance or repair
work.
Before operating the disc sanding device,
you must secure it against tipping.
Securing the disc
B
sanding device
Secure the disc sanding device horizon-

tally ( ) or vertically (
surface.
The enclosed screw clamp (16) must grip
into one of the two receptors (4).
Mounting / dismounting
the sanding table
Dismounting the sanding table:
1. Release the screw (9) underneath the
sanding table (11) using the hexagon
socket wrench enclosed (17).
2. Remove the screw (9) and the washer
(8) and pull the sanding table holder
(10) away from the device.
Mounting the sanding table:
3. To mount the sanding table (11), push
the sanding table holder (10) back
onto the device.

) to the working