Intended Use; Identification Plate; Operating Controls; First Use - Wolf Garten LT 25 eM Originalbetriebsanleitung

EN
¾ Prior to removal of the operating arm, the
device must be switched off beforehand.
¾ Even if all safety and operating instructions
are heeded, there is always a residual risk of
injury and property damage. Always bear this
in mind.
¾ Replace all worn or damaged information
signs on the device.

Intended use

The trimmer with inserted line spool is intended
solely for the care of lawn edges and smaller grass
and lawn areas in private households.
Any other use is classed as an unintended use. The
user is liable for any damage arising from unin-
tended use.
Incorrect/abnormal use
This trimmer should not be used in public facilities,
parks, sports grounds, roads etc. nor in agriculture
or forestry.
To prevent bodily injury to the user, the trimmer must
not be used to cut thicker branches or for shredding
for the purpose of composting.

Identification plate

Position K
The identification plate is located on the trimmer
casing.
Note
The label has the status of a certificate. It
must never be altered or obliterated.
Layout
1 Manufacturer
2 Device group
3 Model name
4 Rated voltage, kind of current
5 Engine speed in rpm
6 Weight
7 Disposal instruction
8 Year of manufacture
9 Guaranteed sound level
10 CE mark
11 Model number
12 Serial number
22
Safety information
¾ Only use the power packs/operating arms
approved by the manufacturer with permanently
installed power packs and chargers.
The designations of the approved power packs/
operating arms with permanently installed power
packs and chargers are listed in the enclosed CE
Declaration of Conformity.
For reasons of safety, installation/removal and
disposal of the power pack in the operating arm
may only be performed by a specialist workshop
during the service life of the device.
Operating elements L
1 Lock-on switch
2 On/off switch on the handle
3 Locking button
4 Working angle adjustment locating button
5 Protective cover
6 Spool cap
7 Line spool
8 Line box
9 Line knife
10 Operating arm *(with permanently installed power pack)
11 Holding area for the hand / fastening area for the optional
middle handle
12 Handle
*Necessary operating element (not supplied)
Supplementary documentation
Make sure the supplied instruction
manuals of the charger and operating
arm are available. Please read and
understand them before using the
device.
Power pack charging
Only charge the power pack using the
charger approved by the manufacturer.
The designations of the approved chargers
are listed in the enclosed CE Declaration of
Conformity.
The power pack is supplied partially charged.
Before first use, fully charge the power pack to
ensure full capacity of the power pack.

Operating controls

First use

WARNING!
Attention!
Safety information