Husqvarna BMG 444 Bedienungsanweisung Seite 13

3. Do the same procedure on the opposite side of the
product.
Operation speed
If the product is operated on a new surface type, set
the speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
To start the product, control panel
without speed adjustment
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Start the dust extractor.
2. Connect the dust extractor hose to the product.
To connect a dust extractor on page 11 .
Refer to
3. Connect the product to a power source. Refer to
connect the product to a power source on page 11 .
4. Stay behind the product and hold the handlebar with
your hands.
5. Tilt the product to lift up the tool plate from the
To tilt the product on page 20
surface. Refer to
6. Push the start button (A).
To start the product, control panel with
speed adjustment
CAUTION:
time while you operate the product. If you
1914 - 001 - 28.06.2022
Move the product all the
B
A
Move the product all the
do not move the product, the surface can
become rough.
1. Start the dust extractor.
2. Connect the dust extractor hose to the product.
To connect a dust extractor on page 11 .
Refer to
3. Make sure that the electrical enclosure is closed.
4. Connect the product to a power source. Refer to
connect the product to a power source on page 11 .
5. Stay behind the product and hold the handlebar with
your hands.
6. Turn the stop button clockwise to make sure that
the stop button is disengaged. Refer to
the product, control panel with speed adjustment on
page 14 .
7. Turn the speed adjustment knob counterclockwise.
Product overview, control panel with speed
Refer to
adjustment on page 5 .
8. Turn the switch for direction of rotation for the motor
To
right or left. Refer to
with speed adjustment on page 5 .
9. Push the start button. Refer to
control panel with speed adjustment on page 5 .
10. If it is necessary, turn the speed adjustment knob
clockwise to increase the operation speed.
To control the operation direction
During operation, the product can pull to the sides. The
direction of the pull is related to the direction of rotation
of the grinding head and how the product is operated.
• Always keep the 2 wheels on the ground during
operation of the product.
• Apply the side forces on the handle to steer the
product.
• Always hold the handle tightly with 2 hands to stay
stable and make sure that the product does not
move laterally.
To stop the product, control panel
without speed adjustment
CAUTION:
from the surface when you stop the motor.
The tool plates rotate for a while after the
motor stops. Dust can go into the air and the
surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
To stop
Product overview, control panel
Product overview,
Do not lift the grinding head
Do not let the product
To
13