GYS E1 AUTO Betriebsanleitung Seite 88

Using the machine interface
Control of the power source
The main screen displays all the information needed before, during, and after welding.
The interface is adjustable with 2 different display modes: Easy or Expert.
1
2
3
Welding
4
5
Torch used (E2 / E3)
1
Schedule
2 Current settings
Long press BP1
3
Gas flow control
Welding mode choice:
4
Welding/Spot-welding/Chain-stitch
5 Push-button no. 1 (BP1)
Navigation thumbwheel
6 Short press to confirm
Long press = General menu
7 Push-button no. 2 (BP2)
8 Current process settings
Easy Mode:
This streamlined display mode is ideal for achieving optimum weld quality.
- 3 welding modes: Welding, Spot-welding and Chain-stitch
- 4 settings : Choice of welding material (synergies), filler wire diameter, thickness, and arc length.
Expert Mode :
This more extensive display mode is designed for more experienced welders.
- Welding modes: Synergic or Manual
- Trigger behaviour: 2T or 4T
- Spot modes: Spot and Spot-Delay
- Selection of the main setting to be presented on the display
- Full adjustment of the welding cycle: Longueur d'arc, inductance, Pré-gaz, Hot Start, Burn Back, Post gaz, etc
8
Easy
Thickness
8
7
6
Expert
1
2
3
4
5
6
Torch used (E2 / E3)
1
Schedule
2 Current settings
Long press BP1
3
Gas flow control
4 Current process settings
5 Push-button no. 1 (BP1)
Navigation thumbwheel
6 Short press to confirm
Long press = General menu
7 Push-button no. 2 (BP2)
8 Advanced settings
Long press BP2
9
Access to JOB
Thickness
9
8
7