Pairing - Geemarc CL7500 OPTI Bedienungsanleitung

Your Headset was paired with the Charging Base at the factory so that
when you switch on the Headset, it will automatically recognise the
Base� However, if for any reason the Headset and Base are no longer
paired, there is a very simple procedure to follow in order to pair the
two devices:
Step : Switch on the headset by press and hold the power button
for 3 seconds, the Power button
Step : Enter Pair mode of the headset by press and hold the Power
button for 5 seconds�
Step : The Power Button
blink green�
Step : Enter Pair mode of the charging base by press and hold the
PAIR Button found on the rear of the Base for 3 seconds ( a pencil with
a sharp point might help with this operation), the Led of the base will
change to blink green�
Step : The Headset and charging base will be paired as shown by the
green light on the headset and charging base�

PAIRING

4
of the headset will change from red to
3
3
should light up a red color�
12
5