Troubleshooting - Assa Abloy UniSlide Bedienungsanleitung

Troubleshooting

What´s wrong?
The door does not open
The motor does not start
The motor starts but stops during
opening
The door does not close
The motor does not start
The motor starts but stops during
opening
The door moves slowly
If the problem continues, please contact your ASSA ABLOY Entrance Systems representative.
20
Change the setting of the mode selector.
Check the mains power and fuse in the building.
Unlock the mechanical locks.
Clean the floor guide.
Check for objects jammed under the door.
Change the setting of the mode selector.
If a presence sensor is installed, check for and remove objects placed in the
presence zone.
Clean the floor guide.
Check for objects jammed under the door.
Prevent traffic from using the door and allow it to close completely.
Reset the operator by setting the programme selector to AUTO and pushing
a narrow object in the small hole on the programme selector.
Issue 2021-01-12
Remedies
1005274-en-10.0