Securing The Machine; Electrical Connection - Miele PWM 920 EL/RH Installationsplan

After aligning the machine, tighten the lock nuts by turning them in

an counterclockwise direction with a wrench. This will prevent the
feet from adjusting themselves.

Securing the machine

The feet of the washing machine must be secured to the concrete

plinth using the fixtures and fastenings supplied.
Fittings supplied are for installation on a concrete floor. For other
types of flooring, please purchase suitable fastening materials sep-
arately.

Electrical connection

The electrical connection must only be carried out by a qualified
electrician who must ensure that all electrical work is carried out in
accordance with applicable electrical regulations and standards
(BS 7671 in the UK).

This washing machine must be connected to an electrical mains
supply that complies with local and national regulations. Please also
observe your insurance and energy supplier's regulations as well as
any health and safety at work regulations.

The required voltage, connected load and fusing rating can be
found on the data plate on the washing machine. Before connecting
the machine to the power supply, please ensure that the mains sup-
ply voltage complies with the values given on the data plate.
Connection to a supply voltage other than the one quoted on the
data plate can lead to functional faults and damage the washing
machine!
If more than one voltage is quoted on the data plate, the washing
machine can be converted for connection to the voltages stated.

Conversion to a different voltage must only be carried out by a
Miele Service engineer or by an authorised Service Partner. The wir-
ing instructions given on the wiring diagram must be followed.
en - Installation notes
27