Installation - Hoover H-HOOD 500 HTSI9CBK5XWIFI Einbau- Und Bedienungsanleitung

CEILING MOUNTING INSTALLATION
IMPORTANT: The angle bars must have an overlap of AT LEAST 100

1) Position the hanging plate on the
ceiling and then mark the position of the
screw holes.
The hanging plate should be securely fixed
to the ceiling,
11 x ST6 (40 mm)screws for wooden ceiling

 8 x expansion bolts for cement ceiling
2) Fix the angle bars to the hanging plate,
using the 8 x M5 screws.
3) Extend the angle bars to the repuired
height and then fix them in position using the
16 x M5 screws and nuts with metal
washers.
4) If your cooker hood is going to
be used in extraction mode, then
you should connect the ducting
hose to the ceiling adaptor at this
point.
Fix the upper chimney section to
the hanging plate, using the 4 x
self tapping screws.
Slide the lower chimney section
onto the
until it sits just below
chimney section.
5
angle bars and raise it
the upper
mm.
�