Subwoofer Parts Description; Loewe Klang Sub1 Transmitter Parts Description; Setting Up The Subwoofer - Loewe klang sub1 Benutzerhandbuch

Loewe klang sub1

Disposal | Licenses | Subwoofer parts description
Loewe klang sub1 transmitter parts description | Setting up the subwoofer
Disposal
Disposal of used electrical and electronic equip-
ment and batteries.
The crossed-out wheeled bin symbol on the pro-
duct or its packaging indicates that this product
must not be treated as normal household waste,
but must be returned to a collection point for the
recycling of electrical and electronic equipment
and batteries. By helping to properly dispose of
this product, you are protecting the environment
and the health of your fellow human beings.
Improper or incorrect disposal endangers the
environment and health. For more information
about the recycling of this product, please con-
tact your local authority or your municipal waste
disposal service.
Licenses
The Bluetooth word mark and logos are regis-
®
tered trademarks of Bluetooth SIG Inc. and any
use of such marks by Loewe Technology GmbH
takes place under license. Other trademarks
and trade names are those of their respective
owners.
2 Subwoofer parts
description
2
2.1 Rear view of klang sub1
1. Volume knob
2. LED indicator
2.1.1 Volume knob operation
Rotate left – Decrease volume.
Rotate right – Increase volume.
Press and hold for at least 3 seconds – The unit
will go into Bluetooth pairing mode.
2.1.2 LED indicator states
Subwoofer state LED indicator state
Standby mode LED is off
On, but not connected LED flashes slowly
to any source
Bluetooth pairing LED flashes fast
Bluetooth connected LED is on
Line in audio signal LED is on
detected
5
2.2 Bottom view of klang sub1
3. Power plug socket
4. 3.5mm line in jack
5. Cable management compartment
3 Loewe klang sub1
transmitter parts
description
1
2
1. USB plug
2. 3,5 mm line input jack
3. LED indicator
4. Pairing button
3.1 Transmitter LED indicator
states
Transmitter state
Not connected
Connected
Bluetooth pairing
3.2 Transmitter pairing button
operation
Long press - Starts Bluetooth pairing mode with
an external device.
Note: Bluetooth pairing expires after 2 minutes if
no external Bluetooth device is found. Press and
hold the button again to restart pairing.
Short press - Reconnects to the last paired
device.
4 Setting up the
subwoofer
3
You can position the subwoofer anywhere on
the floor.
4
To use a wireless connection, do not place the
subwoofer further than 3 m from the Bluetooth
transmitter. You can place the subwoofer further
than 3 m from the transmitter, but we do not
guarantee trouble-free operation.
Connect the power cable to the bottom of the
subwoofer. Secure the cable to the cable ma-
nagement compartment. Finally, plug the power
cable to the mains socket.
The subwoofer powers on automatically and
enters the Bluetooth pairing mode.
Important: Never obstruct the air vents on the
subwoofer. Make sure it is at least 10 cm from
the wall.
1
3
4
LED indicator state
LED flashes slowly
LED is on
LED flashes fast
8