External Sensor; Base Station - Bresser TemeoTrend NBF Bedienungsanleitung

EXTERNAL SENSOR

After inserting the batteries the external sensor starts to transfer the
measured temperature and humidity readings. In order to ensure the
signal is transmitted properly the base station and the external sensor
should be
positioned a maximum of 30 metres apart. The range of coverage
is restricted by brickwork, reinforced concrete, metal windows and
fog. Overlapping radio waves can also impair reception. The external
sensor
measures and transmits the temperature at 40 second intervals. You
can now screw the battery compartment cover back onto the external
sensor.

BASE STATION

Shortly after inserting the batteries the internal temperature is dis-
played and the base station starts to search for the external sensor
for a period of 2 minutes, which is indicated by fl ashing semi-circles
above the CH symbol. If this search has been successful, the semi
-circles stop fl ashing and illuminate continuously and the external
temperature and humidity reading are then displayed.
Setting the units of measurement and height above sea level
for your location:
hPa/mBar fl ashes to the right of the display at the same level where
the moon phase is indicated. You can now use the arrow buttons
in the battery compartment of the base station to alternate between
two units of measurement for the atmospheric pressure (hPa/mBar
or inHg). Confi rm your selection by pressing the UNIT button brief-
ly. Then meter starts to fl ash. Use the arrow buttons again to select
your desired unit of measurement (meter or feet) and confi rm your
selection by pressing the UNIT button. The height above sea level
subsequently starts to fl ash at ‚10'. Now set the correct height above
sea level for your location and confi rm your selection by pressing the
PRESSURE/ALTITUDE button.
40