OHAUS Frontier 2000 Serie Bedienungsanleitung Seite 5

TM
Frontier 2000 Centrifuges
Avoid obstruction of any ventilation grills and allow at least 30 cm clearance around the centrifuge.
Remove all packing material from both outside of the equipment and inside the chamber.
Use precaution when moving or lifting the centrifuge as the equipment is heavy.
2.1 Installation the rotors
Cylinder-shaped Motor Shaft
Applicable model: FC2706 FC2516
Conical-shaped Motor Shaft
Applicable model: FC2516
2.2 Loading samples for angle rotors
a. Clean the drive shaft
as well as the collet with
a clean, grease-free
piece of cloth.
c. Hold the rotor with one
hand and secure the
rotor to the shaft by
turning the fixing screw
clockwise.
a. Clean the drive
shaft as well as the
collet with a clean,
grease-free piece of
cloth.
c. Hold the rotor with
one hand and secure
the rotor to the shaft
by turning the fix
screw clockwise.
EN-3
b. Place the rotor
onto the driven
shaft. Make sure
that the rotor is
fully installed onto
the motor shaft.
b. Place the rotor onto
the driven shaft. Make
sure that the rotor is
fully installed onto the
motor shaft.
d. Put on and
secure the lid for
the rotor before
centrifugation
FC2516