SHX SHX22HEAT100 Bedienungsanleitung Seite 177

Troubleshooting
Problem Cause
No power to the power socket
or main fuse defective.
Power plug has not been fully
inserted.
The appliance was not
switched on using the
main switch.
Tip-over switch has been
triggered.
The room temperature is above the
The heater
temperature set on the thermostat.
does not
switch on.
Overheating protection has been
triggered.
'E2'
is
The temperature sensor is not
shown on
functioning properly.
the
display
Suggested solution
Check the power supply and
main fuse.
Insert the power plug in the power
socket.
Switch the appliance ON.
Return the heater to the normal upright
position.
Normal operation. Appliance
automatically switches on and heats up
as soon as the temperature drops below
the set value.
Immediately
covering the heater (if applicable) and
switch the appliance OFF.
Wait until the heater has cooled down
sufficiently, then switch the power back
ON.
If the heater will not switch back ON, it
may be damaged from the excessive
heat. Switch the appliance OFF and
disconnect it from the power supply.
Contact our technical support service or
other technical personnel.
Switch the appliance OFF! Disconnect
from the power supply and contact our
technical support service or other
technical personnel.
177
remove any objects