Before Initial Use; Setting Up And Connecting The Device - Beem FRESH-AROMA-PERFECT III Bedienungsanleitung

23

Before Initial Use

1. Wipe the device with a clean, damp cloth. Rinse the coffee jug (6), the fi lter insert and the
permanent fi lter and the measuring spoon with a little detergent and clear water.
2. Set up the device and connect it (see the "Setting Up and Connecting the Device" chapter).
3. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run with coffee
beans to remove any possible production residues in the water system and in the grinder. To
do this, follow the instructions in the "Handling and Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
4. Repeat this process twice. Do not drink this coffee!
5. Clean the device and accessories (see the "Cleaning and Care" chapter).

Setting Up and Connecting the Device

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed and matches the
technical data of the device. The plug socket must also be readily accessible after
connection so that the connection to the mains can quickly be isolated.
• Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
• Do not use the device in conjunction with extension cables.
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
1. Place the device on the kitchen unit or another dry, clean work surface, following the safety
notices and the notices provided at the beginning of this chapter.
2. Fully unwind the connecting cable and connect it to a plug socket. You will hear a beep and the
control panel and display (4) will light up.
EN