GUTFELS BLEND 5010 Gebrauchsanweisung Seite 13

disconnect the appliance from the electrical supply
and let it cool down completely before using it again.
6. Disposal
This symbol means that the product must
not be disposed of as unsorted waste with
normal household waste, but must be
brought to separate collection points for
reuse and recycling.
The disposal must comply with the existing
local regulations.
For disposal, the product must be taken to
a collection point for recycling of electrical
and electronic equipment.
7. Warranty
The following terms describing the preconditions
for and scope of our warranty do not infringe the
warranty rights of the ultimate buyer.
Our warranty for this appliance is granted under the
following terms:
As a buyer of a Gutfels appliance you have a
manufacturer's warranty (2 years from date of
purchase).
During this warranty period, you can make your
warranty claims directly on the manufacturer's
Service platform at
www.ggv-service.de.
If an additional warranty is concluded between you
and your dealer, all claims against the manufacturer
will become void after the end of the 24-month
manufacturer's warranty. In this case, please contact
your dealer directly.
Warranty period
The warranty period is 24 months from the date of
purchase (proof of purchase must be presented).
During the first 6 months, After Sales Service will fix
defects in the appliance free of charge on condition
that the appliance is accessible for repairs without
any great effort. During the following 18 months,
the buyer is obliged to prove that the defect already
existed at the time of delivery.
In the case of commercial use (e.g. in hotels,
canteens) or joint use by several households, the
warranty period is 12 months from the date of
purchase (proof of purchase must be presented).
During the first 6 months, After Sales Service will fix
defects in the appliance free of charge on condition
that the appliance is accessible for repairs without
any great effort. During the following 6 months, the
buyer is obliged to prove that the defect already
existed at the time of delivery.
The claim under warranty does not prolong the
warranty period for either the appliance or for newly
installed parts.
Scope of the defect remedy
Within the aforementioned periods, we shall remedy
all defects in the appliance that are demonstrably
due to defective workmanship or material defects.
Replaced parts become our property.
The warranty does not cover:
Normal wear and tear, intentional or negligent
damage, damage caused by non-compliance
with the operating instructions, improper set-up
or installation or by connection to incorrect mains
voltage, damage due to chemical or electrothermal
effects or due to other abnormal environmental
conditions, glass, paint or enamel damage and
possible colour differences as well as defective
bulbs.
Defects in the appliance resulting from transport
damage are also not covered. We also do not provide
any services if - without our special written approval
- work has been carried out on the appliance by
unauthorised persons or parts of third-party origin
have been used. This limitation shall not apply to
faultless work carried out by a qualified person
using our original parts to adapt the appliance to the
technical safety regulations of another EU member
state.
Scope
Our warranty applies to appliances purchased and
in operation in the Federal Republic of Germany or
Austria.
In the case of complaints about defective appliances,
the sender's and recipient's addresses must be in the
Federal Republic of Germany or Austria.
For appliances purchased and operated in other
European countries, the warranty conditions of the
seller apply.
8. CE marking
A conformity assessment procedure
has proven that this product was
manufactured in accordance with
European directives.
With the CE marking, the manufacturer
declares to the responsible EU authorities
that the appliance meets the applicable
conformity requirements, which are
specified in the relevant legal provisions
of the European Union and in harmonized
standards.
A successful completion of the conformity
assessment procedure entitles to affix the
CE mark.
- 13 -
GB