Useful Tips; Initial Cleaning; Maintenance; Prolonged Periods Of No Use - Fagor B-G7051 Installations-, Gebrauchs- Und Wartungsanleitung

o
If the pilot does not light automatically, it is possible to light it manually through the
ignition pipe.
•
Burner ignition:
o
To ignite the burners, press and rotate control M anticlockwise to the required position.
5.2.3 Turing the burners off
•
Turn the M control to the position Pilot
5.2.4 Turning the pilot light off
•
Turn the M valve control to the Off position .

5.3 Useful tips

Read the useful tips listed below carefully in order to get the most out of your barbacue.

5.3.1 Initial cleaning

After the appliance has been installed, clean the grill before use.
Use a damp cloth to clean the grill and then switch on the barbecue to dry it.

5.3.2 Maintenance

FAGOR INDUSTRIAL recommends a service of all the operating components of the barbecue at
least once a year to check their condition and the correct operation of the appliance. This service
must be carried out by an OFFICIAL AND/OR AUTHORISED TECHNICAL SERVICE.
The replacement of any functional component that may affect the safety of either the appliance or
the user should be performed by an OFFICIAL AND/OR AUTHORISED TECHNICAL SERVICE,
using the appropriate original spare parts.
Always clean the machine correctly to prolong the service life of the machine.
•
Remove any waste from the machine at the end of each day.
•
Do not use abrasive, corrosive or acid products, chlorine-based detergents, solvents or
petrol derivatives to clean the machine.
•
Do not use pressurised water to clean the machine.
•
Clean the grill, the deflectors on the burner and the grease collection drawer every day to
prevent the build-up of grease.
•
Clean the burner at regular intervals. To do so:
o
o
o
o
If the power cable is damaged, it must be replaced by the manufacturer, after-sales service or
authorised technical personnel in order to prevent risks.

5.3.3 Prolonged periods of no use

If the machine is kept out of service for a long period of time (holidays, temporary closure, ...),
please observe the following:
•
Close the gas supply.
•
Clean the machine and the adjacent areas thoroughly.
•
Clean the grills and lubricate them with a thin layer of edible oil.
•
Clean the burner tubes.
•
Spray a thin layer of edible oil over the stainless steel surfaces, including the grease
collection drawers.
•
Switch off the mains power supply.

6. FAULTS, ALARMS AND BREAKDOWNS

The steps to be followed in the event of a fault or operating error are described below. The possible causes
and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve
the problem, please contact the technical service.
Remove the grills.
Remove the deflectors over the burner tubes.
Remove the dust and dirt from the burner tubes, taking special care not to block the
holes or make them bigger.
Replace the deflectors and the grills.
, only the pilot will be lit.
41