Temperature Display; Max/Min Weather Data - Bresser MyClimate Thermo-Hygro Bedienungsanleitung

13 Connecting remote sensors
The Weather Station can display the readings from up to 3
wireless sensors* of the same type. Each radio sensor must
be set to a separate channel. Proceed as follows to set the
channel:
1.
2.
3.
4.
5.
6.
*further wireless sensors are optionally available

14 Temperature display

In normal display mode, press the DOWN key to toggle
between °C and °F.

15 MAX/MIN Weather data

The base station stores the maximum and minimum read-
ings for indoor and outdoor temperature as well as for the
humidity:
1.
2.
26 / 32
Remove the battery compartment cover of the wireless
sensor.
Set the channel selection switch to the desired channel
(CH1, CH2 or CH3).
Re-attach the battery compartment cover.
NOTICE! Each connected wireless sensor must be set to
a different channel. If only one wireless sensor is con-
nected, it should be set to CH1.
Press the CHANNEL button on the base station several
times to display the measured values for the individual
channels. The selected channel is shown in the display.
Press CHANNEL button for about 3 seconds to reset the
values and search for a wireless sensor (RF signal).
Press the UP button repeatedly to display the stored
values of the main unit and of the currently set wireless
sensor one after another.
Display sequence: Maximum values > Minimum values
> Current values