Working With The Kneading Hook, Beater And Whisk - Silvercrest SKMP 1300 B3 Bedienungsanleitung

Working with the kneading
hook, beater and whisk
WARNING! RISK OF INJURY!
► Under no circumstances should you place
your hands or fi ngers in the mixing bowl 6
during operation! Danger of injury due to
rotating parts!
► Switch from one accessory to another only
when the drive unit is at a complete standstill!
After being switched off , the drive continues
to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
CAUTION – PROPERTY DAMAGE!
When working with kneading hooks 0,
►
whisk q or beater w, we recommend
allowing the appliance to cool down after
10 minutes of operation.
NOTE
► When you are working with the kneading
hook 0, whisk q or beater w, the drive unit
lid u must be in place. If not, the appliance
will not start.
To prepare the device for tasks involving the knead-
ing hooks 0, whisk q or beater w, proceed as
follows:
1) Push the release lever 2 upwards and move
the swivelling arm 1 to the highest position.
2) Insert the mixing bowl 6 so that the locking
mechanisms on the mixing bowl 6 fi t into the
recess in the base 5. Rotate the mixing bowl 6
clockwise (cf. symbols
base 5) until it is locked and stable.
SKMP 1300 B3
All manuals and user guides at all-guides.com
3) Depending on type of application, mount either
4) Add the ingredients you wish to process to the
5) Push the release lever 2 upwards and push
6) Push the lid 9 onto the mixing bowl 6.
and on the
the kneading hook 0, whisk q or beater w
onto the drive shaft 7:
–
Place the kneading hook 0, whisk q or
beater w onto the drive shaft 7 so that
both metal pins on the drive shaft 7 fi t into
the recesses in the inset 0 q w.
–
Push the inset 0 q w fi rmly onto the drive
shaft 7 until the spring is compressed while
rotating the inset a little anticlockwise (direc-
tion ).
–
Let go of the inset. It is now fi rmly attached
to the drive shaft 7.
mixing bowl 6.
NOTE
► Please note that the dough in the mixing bowl
6 will increase in volume or will be pressed
upwards by the movement during the kneading
or mixing process. Therefore, never fi ll the
mixing bowl 6 to the brim!
the swivelling arm 1 into its working position
with the mounted inset facing downwards.
GB │ CY │ 7 ■