cecotec CHOPBEAT 1500 TITANBLACK GLASS Bedienungsanleitung Seite 7

- Do not touch the device while it is operating.
- Do not run the device for more tan 30 seconds in a row.
After 30 seconds of operation, let it cool down for 2 minutes
before using it again.
- Turn the device off before opening it. Do not open the device
until the motor and blades stop moving.
- Check the power cord regularly for visible damage. If the
cord is damaged, it must be replaced by the official Technical
Support Service of Cecotec, in order to avoid any type of
danger.
- Do not use the device if its cord, plug, or housing is damaged,
nor after it malfunctions or has been dropped or damaged
in any way.
- Do not twist, bend, strain, or damage the power cord in any
way. Protect it from sharp edges and heat sources. Do not
let it touch hot surfaces. Do not let the cord hang over the
edge of the working surface or countertop.
- The device is not intended to be operated by means of an
external timer or separate remote-control system.
- In the event of an abnormal power cut-off, let the device
cool for 20-30 minutes before using it again.
- The device can be cleaned with water up to 100 ºC.
- Turn off and unplug the device from the mains supply when
not in use and before cleaning. Pull from the plug, not the
cord, to disconnect it from the outlet.
- The device is not dishwasher-safe.
- Do not clean the device with any abrasive cleaning agent.
- This device is intended for domestic use only. It is not
suitable for commercial or industrial use. Do not use it
outdoors.
- Do not use any accessory that has not been recommended
by the manufacturer, as they might cause injuries or damage.