Installation - Lacor DECOR 39135 Gebrauchs- Und Instandhaltungsanleitung

1.- Open the large box. Remove all packing materials and protective covering from the unit and
parts. Do not discard the wrapping until you have checked that the blender is working
correctly.
2.- Select the location of the device and follow the instructions for installing it. We recommend
installing the appliance at a height of 1.8 or 2 m from the ground, near an electrical outlet.
!
This device is exclusively for indoor use.
Avoid direct contact of sunlight with the device.
!
Exposing the device to sunlight decreases its performance.
!
Avoid installing the device in areas with high wind, dust or humidity.
3.- Use a drill to make 3 holes in the wall on which you are going to install the mosquito killer. The
holes should have the following characteristics: 5 mm in diameter and 28 mm in depth
(Image 2). Insert a raw plug in each of the holes (Image 3). Take into account the
measurements shown in picture 1 to find out the distance between the holes.
4.- Screw the 3 screws included with the appliance in the holes. The screws must protrude 5 mm
from the wall, in order to place the device (Image 4).
5.- Place the mosquito killer by positioning the 3 holes that are on the back of the base of the
appliance (7) on the 3 screws (Image 5).
6.- Cover the 2 screws that protrude from the appliance at the top with the 2 caps (13) that are
included with the appliance (Image 5).
1
4

INSTALLATION

2
5
3
35