Creating An Offset Felling Cut - EDER Maschinenbau Titan 80 Pro Bedienungsanleitung

i
45 Titan 80 Pro

Creating an offset felling cut

The offset felling cut is obligatory, as it avoids dangerous contact
between the Titan 80 Pro and the chainsaw chain.
The offset felling cut is at least 3 cm higher than the bottom cut of the
notch.
Make the offset felling cut.
>
Danger of splintering!
If the chainsaw comes into contact with the safety wedge or the
Titan 80 Pro, parts can splinter and cause serious injuries.
> Always wear the specified protective equipment when
felling.
Make the offset felling cut.
>
Danger of injury from falling tree!
> Observe the correct dimensions of the hinge.
> Do not cut through the hinge, as the tree can then fall in
the direction of the felling cut and cause serious
injuries.
WARNING
EN
270900_00 | 02.2022