EDER Maschinenbau Titan 80 Pro Bedienungsanleitung Seite 40

270900_00 | 02.2022
Making the felling cut at 60 %
After the notch has been cut and the hinge has been marked, you must
make the felling cut at 60 % (2/3) of the tree diameter. The felling cut is
sawn on the side of the trunk opposite the notch.
Mark the course of the felling cut.
>
Danger of injury from falling tree!
The felling cut must not be made deeper than 60 %, otherwise the
tree could fall in the direction of the felling cut and cause serious
injuries.
Observe the correct dimensions of the hinge.
>
> Make sure that you do not saw through the hinge.
> The felling cut must be parallel to the bottom cut of the
notch.
WARNING
Titan 80 Pro 40