STAMOS POWER2 S-MAG 180 Bedienungsanleitung Seite 68

- Connect the plug of the welding cable contained in the cable harness to the
negative (-) output terminal of the welding machine. Connect the other end of
the welding cable to the wire feeder.
- Connect the control wire contained in the cable bundle to the center terminal
of the welding machine. Connect the other end of the control wire to the wire
feeder.
- Connect the MIG/MAG welding handle to the Euro connector on the front
panel of the wire feeder.
- Connect the ground terminal to the workpiece.
- Turn on the power supply.