Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
Appendix
8.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
Term
Drill sleeve
Drilling spindle
Quick action - drill chuck
Drill chuck
Drill drift
Taper mandrel
Tool
Workpiece
Drilling table
Drill head
Spindle sleeve lever
8.3
Storage
ATTENTION!
Incorrect and improper storage might result in damage or destruction of electrical and
mechanical machine components.
Store packed and unpacked parts only under the intended environmental conditions.
Follow the instructions and information on the transport box:
Fragile goods (Goods require careful handling)
Protect against moisture and humid environment
Prescribed position of the packing case (Marking of
the top surface - arrows pointing to the top)
EN
DH40G | DH40GP
84
Explanation
Fixed hollow shaft which runs in the drill spindle.
Shaft activated by the motor
Drill bit adapter can be fixed by hand.
Drill bit adapter
Tool to release the bit or the drill chuck from the drill spindle
Cone of the drill or of the drill chuck
Drill bit, countersink, etc.
Part to be drilled, part to be machined.
Supporting surface, clamping surface
Upper part of the geared drill
Manual operation for the drill feed
Translation of original instructions
Appendix
Version 1.0.1 - 2020-11-24
Werbung
Inhaltsverzeichnis
