Electrical Safety; Using An Extension Cable - Black Decker GT100 Handbuch

ENGLISH
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
: The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must
read the instruction manual.
G Always wear safety glasses and ear protection.
E Wear gloves when operating this tool.
Immediately disconnect the cable from the mains if it
R is damaged or cut.
Do not expose the tool to rain or high humidity.

Electrical safety

#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.

Using an extension cable

Always use an approved extension cable suitable for the
power input of this tool (see technical data). The extension
cable must be suitable for outdoor use and marked
accordingly. Up to 30 m of 1.5 mm² HO5V V-F extension cable
can be used without loss of product performance. Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
Features
This tool includes some or all of the following features.
1. Trigger switch
2. Front handle switch
3. Front handle
4. Guard
5. Blade
6
6. Blade sheath
7. Cable restraint
This hedge trimmer has the following features for your benefit:
Ergonomically formed handles for comfortable cutting.
u
Machined blades for improved cutting.
u
Dual action blades for reduced vibration.
u
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged and that the blade sheath is fitted
over the blades.
Fitting the guard (fig. A)
Locate the guard (4) into the mounting bracket (8).
u
Push the guard into the bracket until it clicks into place.
u
Warning! Never use the tool without the guard.
Connecting the tool to the mains (fig. B)
Unless the tool is fitted with a mains cable, you will need to
connect an extension cable to the power inlet.
Connect the female socket of a suitable extension cable to
u
the power inlet of the tool.
Loop the cable through the cable restraint (7) as shown to
u
prevent the extension cable from becoming detached
during use.
Insert the mains plug into a mains outlet.
u
Warning! The extension cable must be suitable for outdoor use.
When using a cable reel, always unwind the cable completely.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving
u
parts.
Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When
u
using any tool for prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed
u
when using your tool (example:- working with wood,
especially oak, beech and MDF.)