Operation; Charging The Battery - Wolf Garten Li-Ion Power RR-T 6000 Originalbetriebsanleitung

Operation

Charging the battery

1
Caution! Only use the charger in dry
places.
Before first use, the battery must be charged for 5
hours.
Use only the original WOLF Garten charger
(part no. 092.61.026)!
1. Remove the battery from the device
2. Insert the battery into the charger
3. Connect the charger to the mains
B
supply .
3
Notes on the charger
z LED
flashes green: The battery is be-
ing charged
z LED
lights up continuously in green:
Battery charging complete
z LED
flashes red: Fault (e.g., battery
is too hot)
1
Self-discharge of the rechargeable bat-
teries! Remove the battery from the
charger once it is fully charged.
3
General notes on the battery:
You should observe the following points in
the interest of a long service life of the bat-
tery:
z If the voltage of the battery is low, the de-
vice shuts off automatically. The battery
must be charged in this case.
z The lithium-ion battery must be charged
before long intervals, e.g., prior to stor-
age in winter.
z If the battery is completely discharged,
the charging time is 5 hours.
z The lithium-ion battery may be charged
in any condition of charge and the charg-
ing may be interrupted at any time with-
out damaging the battery (no memory
effect).
G
A B C
A
.
.
B
B
:
Telescope handle
D
Assembly
1. Push the top of the device and the telescope
handle together
into place).
2. Hook in the safety clip at the top of the
device .
Adjusting the working length
1. Open the quick-action lock
2. Set the desired working length
3. Close the quick-action lock
F
Disassembly
In order to be able to cut off branches optimally,
the garden shears may also be operated without
the telescope handle.
1. Loosen the safety clip
2. Press the latching buttons on both sides to-
gether and keep them pressed
3. Detach the top part of the device from the tel-
escope handle
Working with the garden shear
1
The telescope branch shear is meant to
cut branches and twigs.
1
Caution! Sharp cutting edges!
z Keep your hands out of the cutting ran-
J
ge. .
z Ensure that you are standing on firm
ground, especially when working above
head height.
z Keep the blade away from your body.
Preparing the garden shear for operation
z Place the battery as shown in
Switching the garden shear on
1. Press and hold the On / Off button
the unlock button
2. Press the On / Off button
Switching the garden shear off
z Release the On / Off button
H
or
(the snap fit audibly snaps
E
.
.
.
.
.
.
A
and
G H
G
H
.
.
G H
G
/
C
.
or
15