Operation; Switching The Hedge Shears On/Off - Wolf Garten LI-ION POWER HTA 700 Originalbetriebsanleitung

Operation

Times of operation
z Please consult regional/local regulations.
z Inquire about the operating times at your local
regulatory agency.
Charging
A B C
1
Attention! Only use battery charger in
dry places.
Before first use, the battery needs to be charged
for about 1,2 hours.
Use only the original WOLF-Garten charger
(part no. 41A30--E650)!
1. Remove the battery from the device
2. Insert the battery into the charger
3. Connect the charger to the mains voltage
(LED lights up green).
3
Notes on charger
z LED
lights up red: Battery is charging
z LED
lights up green: Charging com-
pleted
z LED
blinks red: Fault (e.g., battery is
too hot)
1
Self-discharge of batteries! Remove the
battery from the charger once it is fully
charged.
3
General instructions:
regarding the battery In order to maintain
the long service life of the battery, always
follow the instructions below:
z The lawn trimmer are automatically swit-
ched off when the battery voltage is low.
The battery must then be recharged be-
fore the shears can be used again.
z Always recharge the lithium-ion battery
prior to any prolonged period of non-use,
i.e. before storing the shears away in au-
tumn.
z The charging time is 1,2 hours for a battery
that is completely empty.
z The lithium-ion rechargeable battery can
be charged at any charge level and char-
ging can be interrupted at any time without
damaging the battery (no memory effect)
G
A
.
B
.
B
B
:

Switching the hedge shears on/off

z Make sure that your hands are steady when
working above head height.
z Hold the blade away from your body.
Motor on D
1. Hold down the safety switch on the bowed
handle .
2. Press the on/off button on the hand grip
the same time.
D
Motor off
z Release one of the two buttons.
Tips for cutting
z Please observe the brooding season of the
birds!
z The ideal hedge cutting form is the trapezoid
E
, which provides for adequate light and
ventilation for all parts of the hedge.
z In order to promote thick growth of young
hedges, only half of new shoots should be cut.
z If the hedge has already reached the desired
height, new shoots can be completely remo-
ved.
z In order to achieve a steady hedge height you
can string up a guide wire at the desired height
and cut along this wire.
z Cutting seasons:
–
Deciduous hedges: May/June and October
(cutback to approx. 1/3 of the total height in
winter)
–
Conifer hedges: April and October
–
Conifers: April and October
E F
at
15