Alutech TR-3019-230E-ICU Montage- Und Betriebsanleitung Seite 39

SETTING THE DOOR END POSITIONS
ACTION
3
Confirming
opening direction
4 OPEN end position With
5
Confirming OPEN
6 CLOSE end
position
7
Confirming CLOSE
8 Exit setup
Y
ATTENTION! After the setup perform several door open-close cycles using
sure that the door leaf moves in correct directions, stops in the end positions required accord-
ing to the door installation requirements. If the end positions need to be adjusted, repeat the
setup (table 3).
TR-3019-230E-ICU / TR-3019-400E-ICU
SETUP OPERATIONS
Press , then press
least three seconds. When the LED makes quick
flashes (~5), release the buttons.
ATTENTION! If the confirmation is not completed,
then when defining the direction of opening,
the button was held for less than 2 s.
Repeat the definition of the opening direction!
move the door to the fully opened
position (LIMIT OPEN). To adjust the position use
as well
Press , then press
for at least 3 s. When the LED makes quick flashes
(~5), release the buttons
With move the door to the fully closed
position (LIMIT CLOSE). To adjust the position use
as well.
ATTENTION! Door leaf lifting rope shall not be
eased off in the end position
Press , then press
least 3 s. When the LED makes quick flashes (~5),
release the buttons
When the buttons are released, the standby mode
activates automatically
and hold them for at
and hold them together
and hold them for at
and . Make
37 37