Remington Ultimate Performance Hair Clipper HC9700 Bedienungsanleitung Seite 6

ENGLISH
TAPER LEVER
• The taper lever settings can be seen on the table below.
• Setting one gives you the length indicated on the fixed comb you are using.
• Using the taper lever will increse this length correspondingly.
TO ATTACH A COMB
• Hook front side of attachment comb on front side of teeth.
• Press back side of comb downwards, until the tab clicks into place.
TO REMOVE THE COMB
• Press upward on the tab to release the comb.
• With tab released, pull comb away from clipper and unhook front of the blade.
INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the first time, start with the maximum
comb attachment.
STEP 1 – NAPE OF THE NECK
• Attach the 3mm or 6mm fixed comb
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – BACK OF THE HEAD
• With the 12mm or 16mm guide comb attached, cut the hair at the back of the head.
STEP 3 – SIDE OF THE HEAD
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm guide comb and continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
• Use the longer length fixed combs of 22mm or 25mm to cut hair on top of the head
against the direction in which the hair normally grows.
• Always work from the back of the head.
6
Setting
1
2
3
4
5
Cut length
1.0
1.15
1.3
1.45
1.6