Working With The Unit - MSW Motor Technics MSW-MPS-01 Bedienungsanleitung

spring-loaded forks to the ends of the stand intended for the front fork and secure
their ends using a clamp.
MSW-MPS-02/ MSW-MPS-03: in the sleeves on the rounded corners of the "A" (or
"V" in the case of MSW-MPS-03) shaped profiles, fix the wheels using M10 bolts,
washers and self-dimming nuts. Then slide two corner profiles "A" of the same size
into the main frame (with carrying handle) until the holes in both are aligned, i.e.
with the so-called through hole. Insert M8 screws into these holes and tighten them
with washers and nuts at their ends. Slide the adapters into the holes at the ends of
the stand, adjust their distance and lock them in position using the knobs.
3.3.

Working with the unit

Drive the stand under the motorcycle wheel, making sure that it is centrally located
inside the unit, i.e. between the frame racks. MSW-MPS-02/MSW-MPS-03: in case
of the rear wheel, fit adapters under e.g. the swingarm (see the second photo
below), or swingarm sheaves (so-called "sliders" or "paddocks" - see the last photo
below). Lay the stand flush with the ground to lift the motorcycle. MSW-MPS-01:
For the front wheel, place the spring fork under the bottom of the fork (first photo
below).