Husqvarna BMG 780 Bedienungsanweisung Seite 15

11. Turn the speed adjustment for grinding discs (E)
clockwise or push the button (F) to increase the
grinding disc speed.
12. Turn the speed adjustment for grinding discs (E)
counterclockwise or push (G) to decrease the
grinding disc speed.
13. Push the button (H) to change the direction of
rotation of the grinding discs.
To operate the product BMG 780 RC
• Operate the product manually with the keypad on the
handlebar or with the remote control.
• Do a pairing operation to connect the remote control
to the product. Refer to
BMG 780 RC on page 15 .
WARNING:
operation with the keypad before you
use the remote control. Make sure that
the product operates correctly.
To do a pairing operation BMG 780 RC
The first time the remote control is used together with
the product, a pairing operation is necessary.
A pairing operation is also necessary if the remote
control is replaced or if you change remote controls
between products.
1. Make sure that the emergency stop buttons is
disengaged. Refer to
emergency stop button on page 10 .
2. Make sure that the product is connected to a power
To connect the product to a power
source. Refer to
source on page 13 .
3. Turn the switch for remote control operation (A)
"ACC". The battery power indicator and the hour
meter (B) comes on.
REMOTE
LOC / ACC
A B
1811 - 001 - 02.05.2022
To do a pairing operation
Always do a test
To do a check of the
C
H
A A
T P
HOURS
4. Push the connection button (A) for 2 seconds.
5. If the connection indicator (B) on the remote control
comes on, the pairing operation is done correctly. Do
the procedure again if the pairing operation is not
done correctly.
To start the product BMG 780 RC
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Start the dust extractor.
2. Connect the dust extractor hose to the product.
To connect a dust extractor on page 13 .
Refer to
3. Make sure that the electrical enclosure is closed.
4. Connect the product to a power source. Refer to
connect the product to a power source on page 13 .
5. Turn the ON/OFF switch (A) to the right and do a
check of the indicator (B) for the power supply failure
(only for 3x230V version).
B
B
A
Move the product all the
A
To
15