EN
Actuate a flush
Actuate manual flush
When you approach the WC, the two sensors on
the actuator plate light up. A manual flush is
actuated by holding your hand in front of one of the
two buttons.
To actuate a flush, hold your hand approx. 15 cm in
front of one of the two buttons. There is no need to
touch the actuator plate.
1
For a full flush, hold your hand in front of the
long button on the left for approx. 0.5–1
second.
2
For a partial flush, hold your hand in front of
the short button on the right for approx. 0.5–
1 second.
For testing purposes, a flush can also be actuated
with a Geberit app.
Make settings with the Geberit App
The following settings can be made with a Geberit app:
• Set the light colour of the buttons
• Set the function of the button illumination
• Activate cleaning mode
• Deactivate automatic flush actuation
→ See "Make settings with the Geberit App", page 43.
32
Actuate automatic flush
An automatic flush is actuated by stepping away
from the WC.
▶
Leave the user detection range.
The automatic flush actuation is activated ex works.
It can be deactivated at any time with a Geberit
app.
9753440651 © 04-2022
970.779.00.0(00)