Assembly - ARGENTO Piuma Bedienungsanleitung

5. Assembly

Carefully remove the bike from the packaging* and remove the protective material taking care not to damage the relevant
aesthetic parts or force the cables and pre-assembled components.
*The bike must be removed from the packaging by two adults to ensure that it is not damaged and avoid the risk of injury
and/or crushing.
After aligning the front of the frame with the rear part by rotating them around the coupling hinge pin, tighten the lever on the
frame opening/closing mechanism as follows:
Insert the securing bracket (A) of the opening/closing mechanism lever into its housing (B) on the rear part of the frame.
Push the lever (C) towards the front of the frame, ensuring that it is secured using the locking device (D).
Positioning the handlebar stem
Raise the handlebar stem until it is vertical; tighten the handlebar stem using the locking device indicated by the letter A.
Positioning the handlebars
Position the handlebars on the handlebar attachment taking care to centre and adjust them correctly so they slot onto the
controls, tightening the handlebar attachment lever (tightening device between the handlebars and handlebar attachment).
10