Environmentally Responsible Disposal - Maico PPB 30 AK Montagehinweise

6 Environmentally responsible disposal

5.3.2 PPB 30 AK + PPB 30 ARE/ARW
5.3.3 PPB 30 AE/AW + PPB 30 ARE BB/ARW BB
5.3.4 PP 45 AK/AE/AW + PPB 30 ARE BB/
ARW BB
For mounting the PP 45 external cover → Shell
installation instructions.
10
5.3.5 Several PPB 30 ARE/ARW
1. When mounting several compensating frames,
proceed as follows: Securely screw the first
compensating frame to the wall. Then, mount
the second frame turned by 90° etc.
6 Environmentally responsible
disposal
Old devices and electronic components may
only be dismantled by specialists with elec-
trical training. Proper disposal avoids detri-
mental impact on people and the environment
and allows valuable raw materials to be reused
with the least amount of environmental impact.
Do not dispose of the following
components in household waste!
Old devices, wearing parts (e.g. air fil-
ter), defective components, electrical
and electronic scrap, environmentally
hazardous liquids/oils, etc. Dispose of
them in an environmentally friendly
manner and recycle them at the ap-
propriate collection points (→ Waste
Management Act).
1. Separate the components according to mater-
ial groups.
2. Dispose of packaging materials (cardboard,
filling materials, plastics) via appropriate re-
cycling systems or recycling centres.
3. Observe the respective country-specific and
local regulations.
Acknowledgements
© Maico Elektroapparate-Fabrik GmbH. Trans-
lation of the original operating instructions. Mis-
prints, errors and technical changes are reserved.
The brands, brand names and protected trade
marks that are referred to in this document refer
to their owners or their products.