Vertical Floor Or Wall Installation; Horizontal Or Ceiling Installation (Sl Smart Model Only); Hydraulic Connections - Olimpia splendid Bi2 SL SMART S1 Serie Installationsanweisung Und Wartung

2.5 - VERTICAL FLOOR OR WALL INSTALLATION

When mounting on the floor with support feet, refer to the individual instructions leaflets supplied and the
relative manual for the mounting of the feet.
N.B. Do not damage the cardboard packaging, the templates needed for correct machine installation
are printed on the back and underside of it.
Use the templates on the packaging (cut along the lines indicated), and trace the position of the two fixing
brackets on the wall (fig. 7). Use a suitable drill to make the holes with and insert the toggle bolts (2 for
each bracket) (fig. 8 ref. A); fix the two brackets (fig. 8 ref. B). Do not over-tighten the screws so that the
brackets can be adjusted with a spirit level (fig. 9).
Fully tighten the four screws to block the two brackets.
Check the stability by manually moving the brackets to the right and to the left, up and down.
Mount the unit, checking that it fits correctly onto the brackets and checking that it is stable (fig. 10).
2.6 - HORIZONTAL OR CEILING INSTALLATION (only for SL, SL SMART)
Using the template, trace on the ceiling the position of the two fixing brackets and the two rear screws.
Using a suitable drill, make the holes and insert the toggle bolts (2 for each bracket) (fig. 11 ref. A); fix the
two brackets (fig. 11 ref. B). Do not over-tighten the screws. Position the machine on the two brackets,
keeping it in position and then fix the two screws into the rear toggle bolts (fig. 11 ref. C), one on each side.
Make sure that there is sufficient inclination of the unit towards the drainage pipe to facilitate the water
drainage (fig. 11 ref. D).
Fully tighten all 6 fixing screws.
For installation of the SL versions, horizontal condensation collection basin accessory kits are available.

2.7 - HYDRAULIC CONNECTIONS

2.7.1 - Pipeline diameter
The minimum internal diameter that must be respected for the pipelines of the hydraulic connections varies
according to the model:
SLR/SL 200 ø12 mm
SLR/SL 400 ø14 mm
SLR/SL 600 ø16 mm
SLR/SL 800 ø18 mm
SLR/SL 1000 ø20 mm
For the position of the pipeline and the wall fixings, refer to the designs
shown in the following sections, based on the specific configuration.
EN - 43
Bi2 SL/SLR-SMART S1