TFA BUDDY 30.3072 Bedienungsanleitung Seite 17

TFA_No. 30.3072_Anleitung
Wireless Thermometer
• Before the final installation, make sure that the meas-
ured values are transmitted from the transmitter at the
desired installation site to the base station.
• Do not use the base station in the vicinity of radiators,
other sources of heat or in direct sunlight.
• Make sure to avoid the vicinity of any source of inter-
ference such as computer screens, TV sets or solid
metal objects. Within solid walls, especially ones with
metal parts, the transmission range (max. 100 m) can
be reduced considerably.
9. Battery replacement
• As soon as the corresponding battery symbol appears
in the display, please change the batteries of the base
station or transmitter
• Please note: When the batteries are changed, the con-
tact between the outdoor transmitter and the base sta-
tion must be restored – so always restart both devices
or start a manual transmitter search.
10. Additional outdoor transmitters (optional)
• When having more than one external transmitter,
select a different channel for each one with the 1/2/3
switch inside the transmitter's battery compartment.
Insert two new AA 1.5 V batteries, polarity as illustrat-
ed. Start the base station operation or the manual
search for the outdoor transmitter:
• Choose the respective transmitter by pressing the
+/CHANNEL button.
• Press and hold the +/CHANNEL button for three
seconds. The last registered transmitter (channel) will
be cancelled.
• Press the TX button in the corresponding transmitter's
battery compartment. The transmission of the out-
door data will take place immediately.
• The outdoor temperature and the channel number will
be shown on the base station display. If you have
installed more than one outdoor transmitter, press the
+/CHANNEL button on the base station to change
between the channels 1 to 3.
• You can also choose an alternating channel display.
Press the +/CHANNEL button. After the last registered
channel (1 to 3) a circle symbol will appear. To deacti-
vate the function, press the +/CHANNEL button again.
20.04.2022 15:37 Uhr Seite 17
Wireless Thermometer
• Press the SET/MAX/MIN button several times to view
the maximum and minimum values of the currently
selected channel.
• After a successful installation close the outdoor trans-
mitter's battery compartment carefully.
11. Troubleshooting
Problem Solution
➜ Ensure the batteries' polari-
No indication on the
base station or the ties are correct
➜ Change the batteries
transmitter
➜ No outdoor transmitter is
No transmitter
reception installed
➜ Start manual search for the
Display "- -.-"
outdoor transmitter
➜ Check the outdoor trans-
mitter's batteries (only use
batteries/rechargeable
batteries with 1.5V voltage!)
➜ Restart the outdoor trans-
mitter and the base station
according to the manual
➜ Choose another place for
the transmitter and/or the
base station
➜ Reduce the distance bet-
ween the transmitter and the
base station
➜ Check if there is any source
of interference
➜ Activate (ON) the DCF
No DCF reception
reception in setting mode
➜ Wait for an attempt recep-
tion during the night
➜ Change the location
(interference!)
➜ Restart the device according
to the manual
➜ Set the clock manually
➜ Change the batteries
Incorrect indication
If your device fails to work despite these measures, please
contact the retailer where you purchased the product from
for advice.
– 33 –