Basics; Getting Started; Select The Display Language, Acknowledge The Crossover Type And Cancel The Demonstration - Kenwood KMM-BT358 Bedienungsanleitung

Basics

Remote control (RC-406)
Remote sensor (Do not expose to bright sunlight.)
Pull out the insulation sheet when using for
the first time.
: Can be remotely controlled with an optionally purchased
remote control.
/ : Remote control functions are not available.
How to replace the battery
To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power
Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
or VOL .
to continuously increase

Getting Started

1
Select the display language, acknowledge the crossover
type and cancel the demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1
Turn the volume knob to select [EN] (English) / [RU] (Russian) /
[SP] (Spanish) / [FR] (French) / [GE]* (German), then press the knob.
[EN] is selected for the initial setup.
Then, the display shows: "2-WAY X ' OVER" or "3-WAY X ' OVER"
"VOLUME KNOB" "TO CONFIRM".
2
Press the volume knob to acknowledge the current crossover type.
• To change the crossover type, see "Change the crossover type" on
page 7.
Then, the display shows: "CANCEL DEMO"
3
Press the volume knob again.
[YES] is selected for the initial setup.
4
Press the volume knob again.
"DEMO OFF" appears.
* Only for /
"PRESS" "VOLUME KNOB".
.
ENGLISH
"PRESS"
5