Delay Mode; General Notes - Rollei HS Freeze 4s Anleitung

Operation

Delay Mode

In this mode you can set a delay time. The flash will fire after this time is over. This
is used, for example, if you want to take a picture with some ambient light, but you
don't want to set the flash on the front nor the rear curtain. This might also be used
if you want to have motion in your picture but one single part of the image in the
middle of that motion should be sharp. Then you can set your camera's shutter time
and calculate the correct delay time that you can enter in the flash menu. Therefore
enter the delay mode and set the time between 00.00 and a maximum of 30.00
seconds.

General Notes

1. FrFreeze Mode can only be used in manual (M. mode and it is focused on
providing the shortest possible flash duration at a given power setting.
2. If the wireless remote control function is activated ((TTL-ALL / TTL-C / TTL-N /
TTL-S / TTL-F), the flash can only be controlled by the corresponding transmitter
that is available as an optional accessory.
3. If the wireless remote control function U7 is activated, the flash can only be
controlled by the transmitter U7 which is available as an optional accessory.
Note that this transmitter does not support High Speed Sync or TTL Mode.
4. If the systems overheats, it will automatically go into an overheat protection
mode. The display will show „OH" which indicates that the overheat protection
mode is activated. In this event the system will stop responding while it recovers.
As soon as the temperature is back to an acceptable level, the flash will start
working again.
5. If you start the continuous shooting mode in your camera, the flash power output
range is only available from 1.0 to 3.0. Note that the flash itself does not have a
continuous shooting mode and there will be no corresponding icon on the flash
display.
33