Mains Connection; Mounting Of The Extension Cable - ATIKA LSH 3000 Originalbetriebsanleitung

edges. Do not use the cable to pull the plug from the
socket.
Protect yourself against electric shocks. Avoid touching
earthed parts with your body (e.g. pipes, heating
apparatus, cookers, fridges etc.).
Do never connect a damaged cable to the mains. Do not
touch a damaged cable before it is disconnected from the
mains. A damaged cable may cause contact with live
parts.
Do not use any defective connection cables.
When working outdoors, only use extension cables
especially approved and appropriately labelled for outdoor
use.
Do not set up any provisional electrical connections.
Never bypass protective devices or deactivate them.
Only hook up the machine by means of a fault-current
circuit breaker (30 mA).
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified
electrician or one of our customer service points. Local
regulations – especially regarding protective measures
– must be observed.
Repairs to other parts of the machine must be carried
out by the manufacturer or one of his customer service
points.
Use only original spare parts. Accidents can arise for the
user through the use of other spare parts. The
manufacturer is not liable for any damage or injury
resulting from such action.
A s
A s
Please observe the enclosed assembling
instructions!
Connect the leaf sucker to the power supply system
only after having finished the complete assembly.
Assembling the suction tube
2 Connect the front (11) on the rear suction tube (10)
and screw them together.
Then, insert the completed suction tube (10+11) in
the machine body (5) and screw both together.
Please make sure that the connectors C and D
are connected to each other!
Fixing the collecting bag
3 At first, hook up the front end of the collecting bag
(12) on the suction tube (11).
Finally, slip the opening of the collecting bag (12) on
the dedicated opening on the machine body (5).
s e m b l y
s e m b l y
Fixing the carrying strap
4 Put the loop of the carrying strap (7) through the
provided opening on the machine body (5).
S
S
Check that the machine is completely and correctly
assembled.
Before using the shredder, make sure each time that
there are no faulty connections (tears, cuts, etc.)
−
there are no damage at the machine
−
all screws are tight
−

Mains connection

Compare the voltage given on the machine model plate
e.g. 230 V with the mains voltage and connect the
machine to the relevant and properly earthed plug.
Only use connection cables with sufficient diameters.
Do not use any defective connection cables.
Connect the machine via a 30 mA fault current safety
switch.
Use connecting or extension cables up to a length of 1.5
m featuring a core cross section of at least 25 mm²
Fuse protection: 10 A

Mounting of the extension cable

1. Plug the female
connector of the
extension cable on the
male connector (14) of
the device.
2. Thread the extension
cable through the pull
relief device (8) as a
loop and hang it up.
3. Make sure that the
extension cable has
enough free motion.
t a r t - u p
t a r t - u p
12