Pre-Operation For Starting - Honda WX15 Bedienungsanleitung

4. PRE-OPERATION FOR STARTING

Before each use, look around and underneath the engine for signs of oil
or gasoline leaks.
1.Install the hose connector.
Be sure to check that the packing is seated in its place and install the
hose connector to the port on the pump.
HOSE CONNECTOR
PACKING
HOSE COUPLING
HOSE CLAMP RING
2.Connect the suction hose.
Use commercially available hose, hose connector, and hose bands.
The suction hose must be of reinforced, noncollapsible construction.
Suction hose length should not be longer than necessary, as pump
performance is best when the pump is not far above the water level.
Self-priming time is also proportional to hose length.
The strainer that is provided with the pump should be attached to the
end of the suction hose with a band, as shown.
CAUTION:
Always install the strainer on the end of the suction hose before
pumping. The strainer will exclude debris that can cause clogging or
impeller damage.
STRAINER
HOSE BAND
HOSE CONNECTOR
HOSE BAND
SUCTION HOSE
9