Schmidt Sportsworld CT 200 Benutzerhandbuch Seite 28

Step 3 M piece installation
40 11
Putting the M piece (44R) through the pedal core shaft (75) of the platform (59) parts, and fixing the M piece (44R) on the
pedal core shaft (75) with the inner hexagon screw (10), cushions (11) and gasket (40). Screwing with an Allen wrench (99).
(Note that the M pieces are divided into left (L) and right (R), which are marked on the package)
Step 4 Installation of center shaft and lower swing
16
Firstly, installing the pre-assembled (34R) + (25R) on the handlebar stand pipe (30) (firstly installing the position shown in
the figure below), then successively penetrating into the lower swing (25R) with the central shaft (21), after that, putting
them into the spring washer (16), penetrating into the handlebar stand pipe(30), the details are shown in the corresponding
position. The other side can be installed as above. Finally, the two ends of the central shaft (21) are fixed with screws (10),
cushions (11) and spring washers(12), fastening with two inner allen wrench(99).
10
11
40
10
12
11
10
44L
59
75
44R
STEP 3
10
11
12
34L
25L
44L
59
44R
STEP 4
26
16
21
30
25R
34R