Reversing The Door - ChiQ MF-415W Benutzerhandbuch

Note: If the above descriptions are inapplicable to troubleshooting, do not disassemble and repair it
yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact
the local store where your purchase was made. This product should be serviced by an authorized engineer
and only genuine spare parts should be used.
When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods
and clean the appliance, leaving the door ajar to prevent unpleasant smells.

Reversing the Door

1. Screw off the screws of the upper hinge cover,
and remove the upper hinge cover.
2. Screw off the three bolts fixing the upper
hinge, remove the upper hinge, and pry off the
door shaft sleeve, magnet and the proximity
switch on the upper hinge cover.
3. Screw off the three bolts fixing the top box
cover on the left side, remove the box cover, take
the wire harness out of the hole, and transfer the
door shaft sleeve from right side to the left side
for installation.
4. Lift up the refrigerator door by 50mm to
remove it.
5. Remove the front leveling foot, screw off the 4
screws fixing the hinge, and remove the lower
hinge.
6. Take out the lower left hinge from the
accessory bag, and install it on the refrigerator.
7. Remove the door stopper and door closer, take
out the door closer from the accessory bag, and
install it on the left side of the door.
10