KEYPAD OPERATION
The keypad includes those keys such as ON/OFF, HOLD, SWITCH, ZERO.
(Note: the above keys can be used in sub-menu to set up Kg-lb conversion, Hold,
Beeper On/Off, Zeroing and backlighting, etc.)
Model
Max. Capacity (kg)
SBS-KW-3
SBS-KW-5
SBS-KW-10
1. [HOLD]
: Press this key to keep the current weight and there is a LED
Modell
Max. Beladung (kg)
indication lamp on the bottom of the display window.
SBS-KW-3
SBS-KW-5
Press this key again when the displaying weight flickers
SBS-KW-10
to cancel the HOLD function.
2. [SWITCH]: Press this key to change between Measured Division
and Hi resolution Division.
3. [ZERO]
: Press this key to set the current weight to zero.
GENERAL SCALE OPERATION
T
o
S
1.
urn
n The
cale
Press the power switch located under the displaying window of scale. The scale's
maximum weighing capacity is first shown, and then the scale goes through a
self-check sequence. 5 seconds later, the scale will stabilize and be ready for op-
eration. (Note: it is recommended to allow scale 3~5 minutes of warm-up time
before starting weighing operation).
z
2.
eroing
In general, the scale shows "0.0kg" or "0.00kg" after it is turned on. In case the
display is showing numerical value other than "0", press [ZERO] on the keypad or
the remote to set the display to "0".
W
M
3.
Eight
EasurEMEnt
a) Once the load is suspended completely, the display shows the weight value of
the load. When the "Stable" indicator is lit, weight value can be recorded.
b) In case there is tare such as cable, load the tare and press [ZERO] to zero the
display to "0"kg. The weight value after this will be the net weight. This will not
change until the tare change or the scale being turned off.
T
o
S
4.
urn
ff The
cale
After weighing operation, press the power switch to shut off the power completely
to prevent the leakage of the battery.
Min. Load (kg)
3000
5000
10000
Min. Beladung (kg)
3000
5000
10000
23
Measured
Division
20
1
40
2
100
5
Genauigkeit
20
1
40
2
100
5
Division Hi
resolution
0,5
1
2
Wahlweise
0,5
1
2
EN