Basic Parameters - Roborock S7 MaxV Benutzerhandbuch

Omni-Directional Wheel
C3
* Clean as required.
C3-1— Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note: The omni-directional wheel bracket cannot be removed.
C3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
Main Wheels
C4
* Clean monthly.
Clean the main wheels with a soft, dry cloth.
Dustbin
C5
* Clean as required.
C5-1— Open the top cover of the robot and
take out the dustbin.
C5-2— Open the dustbin cover and remove
the filter, then empty the dustbin.
C5-3— Fill the dustbin with clean water and
close the cover. Gently shake the
dustbin, and then pour out the dirty
water.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-4— Leave the dustbin and the washable
filter to dry.
Washable Filter
C6
* Clean every 2 weeks and replace every 6-12 months.
C6-1— Open the filter cover and remove
the filter.
C6-2— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C6-3— Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Purchase an additional filter and alternate if necessary.
Water Tank
C7
* Clean as required.
C7-1— Open the water tank and fill it with
clean water.
C7-2— Close the water tank and shake it
gently.
C7-3— Pour out the remaining water as
shown.
VibraRise Mop Cloth
C8
* Clean after each use and replace every 3-6 months.
C8-1— Remove the VibraRise mop cloth
from the VibraRise mop bracket.
Clean the VibraRise mop cloth and
air-dry it.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Robot Sensors
C9
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9-1— ReactiveAI Obstacle Recognition
C9-2— Wall Sensor
C9-3— Mop Wash Sensor
C9-4— Carpet Sensor
C9-5— Cliff Sensors
11
Charging Contact Areas
C10
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the charging dock and the
robot.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.

Basic Parameters

Robot
Model S270RR
Battery 14.4V/5200mAh lithium-ion battery
Weight Approx. 4.7kg
Rated Input 20V 1.2A
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside of
the robot.
Charging Dock
CDZ11RR or CDZ12RR
Model
Rated Power 28W
Rated Input 100-240V~
Rated Output 20V 1.2A
Rated Frequency 50-60Hz
Charging Battery 14.4V/5200mAh lithium-ion battery