Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Water must never come into contact with the tool
•
Ensure the tool is thoroughly dry before using it
•
If available, use clean, dry, compressed air to blow through the ventilation holes (where applicable)
Brushes
•
Over time the carbon brushes inside the motor may become worn
•
Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
•
If you suspect that the brushes may be worn, have them replaced at an authorised GMC service centre
Note: One pair of spare carbon brushes is included with this tool.
Storage
GB
•
Store this tool and its accessories after use in its case, in a dry, secure place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are
not viable for repair.
•
Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with household
waste
•
Contact your local waste disposal authority for information on the correct way to dispose of power tools
Troubleshooting
Problem
Tool does not start when switch is operated
Blade not cutting correctly
Sanding sheets come loose
from sanding pad during use
Unknown mechanical noise
Burning smell or other abnormal operation
Possible cause
No power
Defective switch or tool fault
Speed setting too low
Material may not be suitable for the blade installed
Material not suitable for tool
Blade may be worn
Speed set too high
Too much downward pressure during use
Hook and loop surface of sanding pad worn out
Accessory not securely fitted
Tool fault
Tool fault
8
Solution
Check power supply
Return the tool to an authorised GMC service
centre for repair
Increase speed
Change blade
For some materials, including hardened metals,
compatible blades are unavailable. Revert to alternative
methods of cutting
Replace blade
Reduce speed
Reduce hand pressure
Replace sanding pad
Check blade or other accessory is securely tightened
Stop using the tool and return it to an authorised GMC service
centre for repair
Switch the tool off and disconnect from power
supply immediately. Return it to an authorised GMC service
centre for repair
Werbung
Inhaltsverzeichnis
