Safety Instructions For Colour Application Devices - WAGNER FINISH CONTROL 3500 Originalbetriebsanleitung

FinishControl 3500
5. Service
a) Have your tool repaired only by qualified specialist
personnel and only with original spare parts. This
ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced
by the manufacturer or it's service agent or a
similarly qualified person in order to avoid a safety
hazard.
Safety instructions for colour application
devices
1. Risks of Fire and Explosion
When spraying flammable coatings vapours from
paint and solvents can cause flammable gases to be
produced in the work area (hazard area).
Risk of fire and explosion due to ignition sources in
this danger zone.
The electrically operated spray device contains
potential ignition sources (spark formation when
switching the motor on and off, when inserting and
removing the power plug, due to potential static
electricity at the spray gun)
-> Device must not be used at operating sites that fall
under the explosion protection ordinance.
-> Do not use combustible coating substances and
cleaning agents -> observe product data sheets!
->Always seal paint or solvent containers tightly in
the vicinity of the device.
-> When cleaning devices with flammable solvents,
disconnect the device from the mains and clean
thoroughly with a brush and cloth. Before starting
the device up again, ensure that all traces of solvents
are removed thoroughly. Allow the cleaned parts to
dry completely.
2. Warning: Danger of injury!
Never point spray gun at yourself, other persons or
animals.
3. When spraying paint wear a suitable respirator.
The user should be supplied with a breathing mask. In order
to avoid o upational diseases, the working instru tions
provided by the manufa turer of the materials, solvents
and leaning agents used must be omplied with during
preparation, working with and leaning the equipment.
Prote tive lothing, gloves and, if ne essary, prote tive skin
ream is required to prote t the skin.
4. Warning: When working with the paint spraying
system both indoors and outdoors, ensure that no
solvent-based vapours can form within the area of
the paint spraying system. When working in closed
places a sufficient ventilation must be ensured
to remove the solvent vapours.
5. Warning: The device is not splash proof. It should not
be used, neither outdoors in the rain nor be sprayed
with water nor immersed in liquid. Do not use the
device in damp or wet environments.
6. Attention! Never operate
the device if the nozzle seal
is missing, damaged or
incorrectly mounted. If the
nozzle seal is either missing,
damaged or incorrectly
mounted liquids can enter
the device and increase the
risk of an electric shock.
Check the nozzle seal before
each use.
7. The units may only be used with a fun tional valve. If
paints rises in the ventilating hose (Fig. 1, item 19) do
not operate the unit further! Dismantle and lean the
ventilating hose, valve and diaphragm and repla e the
diaphragm if ne essary.
8. Do not lay the filled spray gun down.
9. Extra tion systems should be installed on-site a ording
to the lo al regulations.
10. The obje t to be oated must be earthed.
11. Caution against dangers that an arise from the sprayed
substan e and observe the text and information on the
ontainers or the spe ifi ations given by the substan e
manufa turer.
12. Do not spray any liquid of unknown hazard potential.
13. Before dismounting the spray atta hment, relieve
pressure by opening the ontainer.
14. Before working on the device, remove the power plug
from the socket.
15. Work or repairs on the ele tri al equipment should only
be arried out by a professional ele tri ian, even if there
are instru tions regarding su h work in the operating
instru tions. No liability will be a epted for improper
installation.
GB
SAFETY REGULATIONS
17