General Guidelines; User Manual - Perel 6000-30 Bedienungsanleitung

Introduction
1.
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device
after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the
device into service. If the device was damaged in transit, don't install or use it and contact
your dealer.

General Guidelines

2.
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
• Familiarise yourself with the functions of the device before actually using it.
• All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
Operation
3.
Opening the safe for the first time
• Remove the battery cover [D] by sliding it to the right and locate the keyhole.
• Insert the override key and turn it counter clockwise.
• Turn the rotary knob [A] clockwise and pull to open the safe.
Note: DO NOT keep the override key(s) inside the safe!
Installing/replacing batteries
• The safe requires 4x AA batteries (type R06); alkaline batteries are recommended.
• Slide the battery cover [D] to the right to open.
• Insert 4 new 1.5V type AA batteries (R06), following the polarity markings inside the
battery compartment.
• The status of the electronic lock is verified, and when everything is working, the display
[E] indicates 'GOOD'.
• Slide the battery cover [D] back in place.
Note: at any time, test the batteries by pressing START [C]. If the batteries are low, the
display will show "Lo-BAE" and batteries should be replaced at once.
WARNING:
Do not puncture or throw batteries in fire as they might explode.
Dispose of batteries in accordance with local regulations.
Keep batteries away from children.
Opening the safe after battery installation
• Press START [C]. The display will show "- - - - - - - -".
• Enter one of the two preset codes: "0000" being the user code, "8888" being the master
code. Confirm by pressing START [C].
• The green LED [F] lights up and the display shows 'OPEN'.
• Turn and pull the rotary knob [A] to open the door within 4 seconds.
08/04/2009
6000-30

User manual

! Please read the manual thoroughly before bringing this
6000-30
3
©2008 Velleman ® Components nv