Electrical Connection And Equipment - EOS SBM-FL150 Montage- Und Gebrauchsanweisungen

Electrical connection and installation
• First ensure that the mains adapter is not connected
• Use the supplied cable to connect to one of the other free sauna bus connections on the sauna
control unit or another module.
• Connect the LEDs to any number of the channels. Note the polarity
• Observe the polarity, anode to +, cathode to - When connecting illumination material with a
joint cathode (-) connect to any cathode (-) connection.
• Define the device address. Usually, up to three coloured light modules are supported in one ca-
bin; their control circuits are controlled in parallel in this case. If several modules are connected,
each address may only exist once. The con# guration is completed via the upper DIP switch.
First module
• Use suitable cable openings to protect the electronics from splashwater.
• We recommend making a cross-shaped opening in the membrane sheath to allow the module
plug to be fed through.
• Screw the upper part of the housing on again using the provided screws-
• Reconnect the shockproof plug.
• Switch the control unit on
Upper mounting hole
210 mm
Mounting holes
Fig. 4.1
22
Second module
EN
Third module
Upper mounting hole
Attachment hole
Fig. 4.2
Fig. 3
130