Special Functions - Marmitek DoorPhone 120 Gebrauchsanleitung

• As soon as the handset is answered, the door unit doorbell indicator light (2) shall
burn constantly. The caller can communicate by speaking into the microphone (3).
To prevent echo, there is a hands-free function built in, which makes sure that when a
visitor speaks into the microphone (3) of the door unit, the loudspeaker (4) shuts off.
Beware! This means when the visitor is speaking into the microphone, he will not be able
to hear you, therefore wait with answering until the visitor has finished speaking.
• When receiving a call from the door unit, the symbol
can answer the call by pressing on the speech button (9). At the same time the symbol
will appear on the display. From this moment on, it is possible to speak to the visitor.
• Beware! The system has a built-in conversation time limit of 60 seconds, which is for if you
forget to break the connection after a conversation has ended. When you are reaching this
time limit, you shall hear a signal tone. If required, you can extend the conversation time by
another 60 seconds by pressing on the speech button (9). There is no limit to the amount
of times you can extend the conversation.
• In case you have also connected an electric door opener, you can open the door during the
conversation by briefly pressing on the door-open button (11). After approximately 4-5 seconds,
the symbol will appear on the LCD screen. This function can be switched on or off with the
use of the Door open on/off dipswitch (20) on the handset. Furthermore, the door can only be
opened when there is a connection between the handset and the door unit.

7. SPECIAL FUNCTIONS

• Ringtones; use the button (14) to choose the desired ringtone.
• Ring mode; use the button (15) to select the ring mode. Depending on your selection,
symbols (F till L) will appear on the screen. Note; in case you select a combined function,
the battery will need to be charged more often, at the cost of the battery's lifespan.
• Loudspeaker volume; using the buttons (12-13), you can adjust the loudspeaker volume
of the receiver (16) during a conversation.
• Extra door unit; this function is not active. Make sure that the yellow backdoor on/off
select dipswitch (21) is on the 'OFF' position. A wrong setting can result in a false notice
'Out of range'.
• Not home; when you have not answered a call from the door unit, the symbol
appear on the LCD screen. This symbol will alert you of the fact that someone has been at
the door. Pressing on the on/off button (8) will make the symbol disappear.
• Out of range; when your handset is beyond the reach of the door unit, you will hear a
signal and the symbol
as soon as you are out of range but rather when you are out of range for over 30 minutes.
Pressing the on/off button (8) will stop the alarm temporarily, but the symbol
displayed. As soon as you are within reach of the door unit, the alarm will stop and the
symbol will disappear.
This signal will also appear when the batteries of the door unit are low, and if the external
power supply fails or if the switch for the extra door unit is on the 'ON' position while there
is no extra unit installed.
14
will appear on the display. Beware; this notice will not be activated
shall appear on the display. You
will
will remain
© MARMITEK