Maintenance / Cleaning - Delabie TEMPOFLUX 3 AB Bedienungsanleitung

OPERATION
• Operate by pressing the anti-blocking push-button with automatic time flow shut-off.
INSTALLATION
• Pressure: 1 - 5 bar (100 - 500kPa), we recommend 3 bar (300kPa).
• Flow rate required for operation: 1 l/sec.
• The valve must not carry the weight of the (supply and outlet) pipework.
If this advice is not followed, water may leak into the wall.
DELABIE cannot be held responsible for any ingress.
FOR FURTHER INFORMATION PLEASE CALL DELABIE TECHNICAL SUPPORT UK: 01491 821821.
ALL OTHER MARKETS: +33 (0)3 22 60 22 74.
Our products are compatible with grey water and rain water as long as they are filtered, and have PH levels between
6.5 and 9.5.
ADJUSTING THE FLOW RATE
• The flow rate can be adjusted from 2 to 9L:
• Turn the stopcock handle (Fig. H page 4) until reaching the desire flush volume.
REMEMBER
• Our mixers must be installed by professional installers in accordance with current regulations and
recommendations in your country, and the specifications of the fluid engineer.
• Sizing the pipes correctly will avoid problems of flow rate, pressure loss and water hammer (see calculation
table in our brochure and online at www.delabie.com).
• Protect the installation with filters, water hammer absorbers and pressure reducers to reduce the frequency
of maintenance (recommended pressure from 1 to 5 bar (100 to 500 kPa) maximum).
• Install stopcocks close to the mixer to facilitate maintenance.
• The pipework, filters, non-return valves, stopcocks, bib taps, cartridge and all sanitary fittings should be checked
at least once a year, and more frequently if necessary.
MAINTENANCE
• Backflow of water at vacuum breaker: check that the tube isn't against the ceramic and that the elbow has
a radius of curvature of around 50mm.
• No flush: dynamic pressure too weak, oversized pipework, or 90° flush tube.
Beware: do not grease the inside of the mechanism.
MAINTENANCE & CLEANING
• Cleaning chrome, aluminium and stainless steel: do not use abrasive, chlorine or any other acid-based
cleaning products. Clean with mild soapy water using a cloth or a sponge.
• Frost protection: drain the pipes and operate the mixer/tap/valve several times to drain any remaining water.
In the event of prolonged exposure to frost, we recommend taking the mechanisms apart and storing them indoors.
For the UK market only: Tel. 01491 821 821 - email: technical@delabie.co.uk
For all other markets: Tel. +33 (0)3 22 60 22 74 - email: sav@delabie.fr
After Sales Care Support:
The installation guide is available on: www.delabie.co.uk
The installation guide is available on: www.delabie.com
EN